This is an industrial 8-ch relay module controlled via RS485 bus, utilizing Modbus RTU protocol. It features embedded protection circuits such as power isolation, magnetical isolation, and TVS diode, etc. It also comes with an ABS enclosure. The Modbus RTU Relay is very. Convert the EIA-485 port of an SEL-300 series relay to a point-to-point fiber-optic port. Improve safety, signal integrity, and reliability by using two optical fibers instead of wire to transfer bidirectional serial data plus an IRIG-B time synchronization signal. Apply for instrumentation. The input channels of the Lucid485 Serial Modbus Digital IO Module are carried out optical and potential insulated in order to protect the hardware and give higher flexibility in design.
The FR485 is a RS-485 to fiber optic convertor module available as a single fiber pair output repeater or dual fiber pair output repeater. The FR485 uses OPTEK's b 850nm, transmitter and receiver with the “ST” connector receptacles for 62. 5-125mm (50/125mm) fiber optic cables. A verification email has been sent to {0}. These systems support various field bus protocols, including MODBUS, MODNET-1/SFB, BIT-BUS, SAIA-S-BUS. The Westermo range of fibre optic modems ensures reliable communications over multimode and single mode fibre optic cables. With transparent operation, our fibre optic modems act as converters for serial RS-232, RS-422, RS-485 and PROFIBUS protocols. It converts electrical RS-485 signals into optical signals, ensuring high-speed, interference-free data transmission. These devices are independent from the serial protocol and they are adapted for Modbus, Modbus+ and IEC131.
[PDF Version]
Optical fibers require special care during installation to ensure reliable operation. Installation guidelines regarding minimum bend radius, tensile loads, twisting, squeezing, or pinching of cable must be followed.
Contact us for competitive quotes on any of our power communication and smart grid products
Get a Quote